Home THE TRIALS CAR Front End Struts etc. by Grant Campbell

Click on an image for enlargement & further explanation


Back End

Brakes

Engine

Front End

Front End 2

Frame

Fuel tank

Steering

Tyres

Wheels

Other cars

The Front End on my car is really what makes this car tick. When I built the first of this type of car I'd wanted something that would actually steer. At the time some cars had beam axles, ala Austin 7 and Ford 10. Others built by the likes of Dale Shaw & Barry Hudson used double wishbones. Although we all knew something of what I suppose is the current English design, like Syd Hirst's of NZ, nobody had done anything with them here. Certainly not with a rear engined car. The difference using a rear engine configuration like the VW meant that I was fairly limited in what I could achieve with the rear end travel so the next best thing was to get the front to do all the travelling. Right from the start I wanted to use components from very ordinary cars so spares wouldn't be a problem. I'd fixed the idea of a strut type in my mind, and after some searching found that the KE20 type Corollas had pretty much all I needed. Cheap & plentiful.

The whole front of the car is held up at this point. To get this bracket over the frame I just left the gaps at the bottom open, then bolted the little plates on via 1/4" Unbrakos.